Hot take: most people are setting their door contacts too tight and it's costing them callbacks
I keep seeing this on installs around here, guys setting the gap on recessed door contacts at like a quarter inch on wood frames. Wood moves with the seasons, and I've had three callback trips this month to houses in the same subdivision where the contact was fine in October and gaping by February. What bugs me is the fix is so small, just set it a hair looser and make sure the magnet side has a little wiggle room in the hole, and you stop getting those nuisance alarms when the humidity shifts. I learned this the hard way after a client in a new build called me four times in one month saying her back door kept beeping. I pulled the contact, saw the gap had opened up maybe an eighth of an inch, and it was enough to trip it. On metal frames you can run them tighter, they don't swell, so it depends what you're drilling into. How are you all setting your gaps on exterior doors, do you go by the spec sheet or your own feel?
Wood frames doing the seasonal cha-cha and guys still drill them tight as a drum, shocking. Honestly the contact doesn't care about the spec sheet as much as the house does. If the door swells in February, the sheet isn't the one getting the callback.