Chose a $180 stud welder over a $900 MIG setup for my first dent pull job, still not sure I made the right call
Back in 2019 I got a beat up Civic with a nasty crease in the rear quarter and had to pick between a cheap stud welder or saving up for a full MIG. I went with the stud welder since it was $180 and I could pick it up that same day at the shop supply place off Lamar. It got the panel pulled and I learned a lot about heat control, but I still see tiny shrinkage spots when the light hits it right. Fast forward to now and I use the stud gun way more than I thought I would on door dings and small dents. Plug welds on structural stuff still need the MIG though, so I ended up buying one two years later anyway. Curious what the rest of you started out with, did you go cheap first or save up for the real machine?
My first "paint job" was a rattle can on a 1994 Ranger and I sprayed it so close the paint ran like I was pouring syrup. I went the cheap route too and got a $40 Harbor Freight grinder plus a used heat gun that smelled like burnt plastic. That combo taught me more about patience than any expensive tool could, mostly because I had to redo everything twice. Your stud welder story sounds like a win by comparison, at least the dents actually came out.