Hit 500 drywall screws in one sitting and finally stopped hating my screw gun

I always thought my driver was garbage because screws kept stripping, but then I counted 500 screws on a 12x12 shed and realized the clutch was set way too low. What number made YOU guys realize your tool setup was the problem, not the tool?

1 comments

1 Comment

ryan95216h ago

My first clue was when I couldn't drive a single 2-inch deck screw without the bit jumping out. I switched to a #2 square drive bit and set the clutch to 15, and it felt like a whole different tool. Sometimes it's just a $10 fix that makes you look like you know what you're doing.