Just realized G54 work offsets beat touching off every part by hand, and I'm never going back
I ran a batch of 40 aluminum brackets last month and touched off every single one with an edge finder like I always did. Took me about 15 minutes a part just setting zeros, so over 10 hours wasted on setups alone. Then a guy at the shop in Tulsa showed me how to set G54 once off a stop and just swap parts in and out. Same batch came out to 4 minutes a part and all 40 held within .001 on the pin gauges. I know some of you old school guys will say fixtures are for people who can't indicate, but the math doesn't lie. What's your go-to work offset setup for repeat parts, and do you run G54 or G55 for a second vise?