My truck's blend door actuator died in January and I had to drive 20 minutes to the station in a freezer
So last month my heat quit on me, middle of a cold snap here in Minneapolis, and I'm sitting at a red light scraping frost off the inside of the windshield with a coffee lid. Turns out it was the blend door actuator, that little plastic gear box buried up under the dash that decides if you get hot or cold air. The part itself is like $40 but you have to pull half the dash apart to reach it, and the shop quoted me $650 in labor. That right there is the design flaw to me, a tiny plastic gear that fails and you basically have to disassemble the truck to swap it. I ended up doing it myself in a buddies garage over a Saturday, lost one 10mm socket to the void, and my hands looked like I fought a cat. Whoever decided to hide a wear part back there should have to fix one themselves. Has anybody found a trick to reach that thing without pulling the whole dash, or am I just doing it the hard way?