Chasing a 0.003 inch taper on a shaft that turned out to be a chuck problem
I spent about 3 hours over two days trying to figure out why a batch of 4140 shafts kept coming out tapered by 0.003 inches over 6 inches, and I was ready to blame the tailstock alignment. Turned out the three-jaw chuck jaws were worn uneven on my old Okuma, and a dial indicator on the part near the jaws showed the runout plain as day once I finally checked. A $40 set of soft jaws and a re-bore fixed it in 20 minutes. Has anyone else had a chuck fool them into chasing a taper that wasn't a taper at all?